A Research On The Potential Of Local Natural Fiber To Produce Handmade Papers For Drawing, Painting And Printmaking

• Main Author: Noor, Ervina Efzan Mhd
• Format: Thesis
• Language: English
• Published: 2013
• Subjects: TN1-997 Mining engineering. Metallurgy
• Online Access: http://eprints.usm.my/43372/1/Ervina%20Efzan%20Binti%20Mhd%20Noor24.pdf; http://eprints.usm.my/43372/

The increased use of electronic devices has increased the usage of solder connections. Lead, the prime solder hitherto used, is hazardous to human health and the environment. Thus, replacing Sn-37Pb with a lead-free solder is one of the most important issues in the electronics industry. As such, the characteristics of In-Bi-Sn and In-Bi-Zn compared with that of the Sn-Ag-Cu solder alloy were studied. In the differential scanning calometry analysis, In-Bi-Sn and In-Bi-Zn system alloys presented a low melting temperature of 61.3 °C and 72.3 °C, respectively. Surface tension and contact angle of In-Bi-Sn and In-Bi-Zn lead-free solder alloys were measured on Cu substrate and different surface finishes at 100, 120 and 140 °C reflow. Sessile drop measurements showed that the contact angle depended on the reflow temperature. The contact angle gradually decreased from 30.76° to 17.25° as reflow temperature increased from 100 to 140 °C and for In-Bi-Sn and In-Bi-Zn solder alloy on Cu substrate, ranged from 58° to 7° after wetting on Ni/Cu substrate at the same reflow temperature range (100 to 140°C). Energy-dispersive X-ray analysis found two layers of intermetallic compound in the In-Bi-Sn solder alloy: Cu6Sn5 and Cu11In9 (scallop shaped) and Cu11In9 (brightly coloured) with Cu and Sn/Cu substrate. The IMC between the In-Bi-Zn solder alloy could be observed: Cu5Zn8 (continuous planar) and Cu11In9, a minor IMC layer with Cu and Sn/Cu substrate. However, only one type of IMC was formed between both solders (In-Bi- Sn and In-Bi-Zn) and Ni/Cu substrate, which was InNi2. As the reflow temperature increased, the shear strength of the In-Bi-Sn and In-Bi-Zn solder alloys on Cu, Ni/Cu and Sn/Cu joints improved due to reduced contact angle and larger spreading area.