Composite optimization of automotive carbon fiber strut bar using hyperworks optistruct

• Main Authors: Razak, M.S.A., Othman, M.N., Sulaiman, S.N., Ramli, Rahizar, Sanada, Y.
• Format: Conference or Workshop Item
• Published: 2021
• Subjects: TL Motor vehicles. Aeronautics. Astronautics
• Online Access: http://eprints.um.edu.my/35569/; https://www.scopus.com/inward/record.uri?eid=2-s2.0-85103117597&doi=10.1088%2f1742-6596%2f1793%2f1%2f012072&partnerID=40&md5=0ff08798c971f2738d12b2cd55eb27a2

Front strut bar is an automotive part commonly used for McPherson suspension system to minimize load on the strut tower by tying both left and right strut with a single bar. By distributing the force acting on a single strut to both strut tower, the strut bar minimizes the chassis flex which improves ride and handling especially during cornering. Therefore, strut bar should be stiffer but lighter at the same time to reduce vehicle weight towards fuel efficiency and lower carbon emission. This research attempts to design a lightweight carbon fiber reinforced polymer strut bar to replace conventional steel strut bar with equivalent stiffness. For validation, a steel strut bar model is analyzed by conducting experimental modal analysis to determine their natural frequencies and the corresponding mode shapes. These results were compared to simulation results. Later, the dynamic behavior of CFRP and the equivalent mode shapes were analyzed and correlated with static loading test results. Combination of different ply orientation and stack sequence results in the design of an optimized carbon fiber strut bar achieved 48 reduction in weight, up to 40 higher natural frequency while improving or preserving the static and dynamic performances compared to the steel strut bar. © Published under licence by IOP Publishing Ltd.