Test engine bed TD-10 upgrading for radical combustion testing / Effandi Mohamad Jamari and Mohamad Shahruddin Kandar

• Main Authors: Mohamad Jamari, Effandi, Kandar, Mohamad Shahruddin
• Format: Student Project
• Language: English
• Published: 2001
• Subjects: Miscellaneous motors and engines.Including gas, gasoline, diesel engines; Internal combustion engines. Spark ignition
• Online Access: https://ir.uitm.edu.my/id/eprint/75069/1/75069.pdf; https://ir.uitm.edu.my/id/eprint/75069/

The objective of this project is to make a necessary upgrade and maintain the availability of the existing equipment TD-10 engine test bed. The second objective is to design a new measurement acquisition device from the engine, so that it can be recorded into the computer for further analysis. The data acquire is in form of torque, temperature and the speed of the engine. Advance measurement, computer system is used and the data are log in into computer using Adam Data Acquisition Module (ADAM) interface. The technique need to be reprogrammed, so that the ADAM module output can be read and analysis in the computer, and also determine the suitable output from instrument panel on engine test bed. Using a new engine (Yamaha RX-Z) attached to TD10 engine test bed to analyze their performance under several load and variation of speed. Dynamometer is used to determine their torque and consequently determine their achieved brake power. Some modifications have been made on that engine such as attached an electric starter motor to start the engine easily. The previous student's project used the pull rope type to start the engine. With the attachment of the starter motor, we designed the gears that act as a flywheel. The design procedure is very difficult since all the aspect has been considered such as the number of teeth, the selection of material, the machining process, and the like. We use carbon steel as materials because it is suitable for particular job and long lasting. We bought and machine it using gear hobbing according the specification that has been satisfied. After installation less vibration effect and the gear look center and nice contact with starter motor. To measure the torque, dynamometer is used and one shaft is used to connect between engine and dynamometer. Failures to design according their standard cause failure to shaft.