Study on concrete performance using treated POFA as a partial replacement of cement / Mohd Afiq Mohd Azham

• Main Author: Mohd Azham, Mohd Afiq
• Format: Student Project
• Language: English
• Published: 2019
• Subjects: Materials of engineering and construction; Composite materials.; Cement, lime, mortar, etc.; Strength and testing of cement, etc.; Environmental protection
• Online Access: https://ir.uitm.edu.my/id/eprint/39608/1/39608.pdf; https://ir.uitm.edu.my/id/eprint/39608/

Palm Oil is used to produce cooking oil and it waste called Palm Oil Fuel Ash (POFA). POFA is one of the wastes that have same chemical properties as cement which is silica, calcium oxide and etc. Due to the development, the demands in cement used in concrete were high to fulfil their desire. The cement currently used is not suitable for sustainable environment where the cement industry is the primary producers of carbon dioxide (CO2). This would make the natural resources decreases and cannot be used for other purposes. The objective of this study is to study the effect of optimum molarity of treated POFA towards the compressive strength with 10% replacement of cement and to investigate water absorption on various molarity of treated POFA in 10% of replacement of cement in concrete. POFA were collected at industry landfill to treat at the environment laboratory by using various molarity of sulphuric acid, H2SO4. Then the treated materials were used on concrete mix of 50 mm x 50 mm x 50 mm mould. 54 cubes sample were being produced to test on compressive strength and water absorption by following the standard BS1881 to check the effect of the treatment of the POFA. From the result obtained, the concrete with partially cement replacement by using POFA treated with 5mol of sulphuric acid is the optimum value that gets from the compressive strength test and also achieved the design strength which is C25/30. The compression strength for the concrete with 5 mol treated POFA and OPC were compared as the result was 44.77 N/mm2 and 47.26 N/mm2 respectively. The higher the molarity of the sulphuric acid after 5mol shows that the compressive strength were been decrease.