Synthesis and characterization of palm based polyurethane composite with river sand as a filler / Farid Abdul Aziz

• Main Author: Abdul Aziz, Farid
• Format: Student Project
• Language: English
• Published: Faculty of Applied Sciences 2017
• Subjects: QD Chemistry
• Online Access: http://ir.uitm.edu.my/id/eprint/25465/1/PPb_FARID%20ABDUL%20AZIZ%20AS%20N%2017_5.pdf; http://ir.uitm.edu.my/id/eprint/25465/

The use of river sand as a filler in synthesizing polyurethane (PU) have potential benefit to synthesize PU composite. This study carried out to determine the potential of river sand and palm oil in preparation of rigid PU composite. The river sand was first sieve to reach the micro size. Then the palm oil used, which is palm kernel oil was then mixed with polyhydric compound to synthesize polyol via transesterification reaction. The PKObased polyol was then mixed with other chemicals at different ratio to form PU control rigid foam. Then different composition of river sand was used, which is 5%, I 0%, and 15% was used to synthesize PU rigid foam with different composition. The formation of urethane linkage (NHCOO) backbone in PU foam was confirmed using FTIR at wavenumber 3 313 cm- 1. The morphological structure of the surface was analyzed using scanning electron microscope at 20 x, 50 x, 150 x and 500 x magnification . The compression test of polyurethane with 15% filler have average compressive load of 8.344 kPa which is higher than other composition which is 6.662 kPa for 5% filler and 7 .6630 kPa for I 0% filler. This study shows that adding filler to PU increases its structure and strength of the composite. TGA analysis at T 10 values for PU control and PU river sand were almost identical. However, the T50 values of the hybrids increased to 457.34 °C