Effect of particle loading on the stability of the water based iron-oxide nanofluids

• Main Authors: Rahat, Arifutzzaman, Ismail, Ahmad Faris, Khan, Ahsan Ali, Alam, Md Zahangir, Rahman, Saidur
• Format: Article
• Language: English; English
• Published: Science and Engineering Research Support Society 2020
• Subjects: TJ Mechanical engineering and machinery; TP200 Manufacture and use of chemicals
• Online Access: http://irep.iium.edu.my/83764/1/83764_Effect%20of%20Particle%20Loading%20on%20the%20Stability.pdf; http://irep.iium.edu.my/83764/2/83764_Effect%20of%20Particle%20Loading%20on%20the%20Stability_SCOPUS.pdf; http://irep.iium.edu.my/83764/; http://sersc.org/journals/index.php/IJAST/article/view/3697/2539

Dispersion stability is a crucial challenge for a nanofluid to obtained a uniform dispersion. The main aim of this research is to develop stability monitoring approach by experimental investigation of ultra violet-visible (UV-vis) absorbance of deionized water (DW) based ironoxide (maghemite: MH) nanoparticles dispersed nanofluids (MH/DW). Five different samples were prepared with increasing the loading of MH nanoparticles varied from 0.065 to 0.157 mg/ml in DW. Primarily digital photographs were captured to observed the sedimentation of MH/DW the nanofluids. A method was developed to monitor the quantitative stability of relative concentrations of MH/DW nanofluids. Optical absorbance measurements were conducted using UV-vis absorbance spectroscopy by varying the light wavelength from 200 to 800 nm. Photographs of MH/DW nanofluids after preparation of ~ 25 days shown uniform and there was no precipitation was visible in the suspensions. For a certain loading of MH particle, with the increasing wavelength absorbance was found to be increased. Absorbance peaks were created at wavelength of ~ 360 nm and then decreased monotonically with the increasing wavelength. The relative concentration of the MH/DW nanofluids was declined when increase the precipitation concentration with time due to slight agglomeration. After ~ 600 hours, the minimum and maximum precipitation rates were found ~ 0.27 and ~ 2.5 % for MH/DW nanofluid with the MH concentration of 0.065 and 0.157 mg/ml respectively. Amount of MH nanoparticle loading affects the rate of sedimentations of the produced MH/DW nanofluids.