Effect of TiO2 and Al2O3-ethylene glycol-based nanofluids on cutting temperature and surface roughness during turning process of AISI 1018
This paper presents the effect of TiO2 and Al2O3-ethylene glycol based nanofluids on cutting temperature and surface roughness during turning process of AISI 1018. Minimum quantity lubrication (MQL) method has been recognized in minimizing the usage of cutting fluid, as a step to achieve cleaner...
Saved in:
Main Authors: | , , , |
---|---|
Format: | Conference or Workshop Item |
Language: | English English |
Published: |
Institute of Physics Publishing
2020
|
Subjects: | |
Online Access: | http://irep.iium.edu.my/83732/1/83732_Effect%20of%20TiO2%20and%20Al2O3-ethylene%20glycol-based_conf.%20article.pdf http://irep.iium.edu.my/83732/2/83732_Effect%20of%20TiO2%20and%20Al2O3-ethylene%20glycol-based_scopus.pdf http://irep.iium.edu.my/83732/ https://iopscience.iop.org/article/10.1088/1757-899X/736/5/052033/pdf |
Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
Summary: | This paper presents the effect of TiO2 and Al2O3-ethylene glycol based nanofluids
on cutting temperature and surface roughness during turning process of AISI 1018. Minimum
quantity lubrication (MQL) method has been recognized in minimizing the usage of cutting
fluid, as a step to achieve cleaner environment and sustainable machining. However, the low
thermal conductivity of base fluid in minimum quantity lubrication system caused the
insufficient removal of heat generated in cutting zone. Addition of nanoparticles to the base
fluid was then introduced to enhance the performance of cutting fluids. In this study, the
machinability of AISI 1018 (mild steel) was investigated under dry machining and nanofluid
minimum quantity lubrication method. Two types of nanofluids (TiO2 and Al2O3 nanofluid)
with concentration 0.05, 0.15 and 0.3 wt.% were used in this study. The experiments were
conducted on lathe machine, using tungsten carbide as cutting tool. Three cutting speed (350,
550 and 750 m/min), three depth of cut (0.5, 1.0 and 1.5 mm) and fixed minimum quantity
lubrication system nozzle pressure (5 bar) were applied throughout turning operation. To
determine the relationship between machining parameters and cutting temperature and surface
roughness values were measured. Based on results obtained, the cutting temperature of
workpieces with usage of nanofluids in MQL system gave lower value compared to dry
machining. The surface roughness of machined parts was also improved under NFMQL
methods. In conclusion, when the nanofluid-MQL method was employed, the amount of
cutting fluid was reduced and machining performance improved. |
---|