Investigation of process parameters for stable micro dry wire electrical discharge machining

• Main Authors: Banu, Asfana, Ali, Mohammad Yeakub, Abd Rahman, Md Nizam, Konneh, Mohamed
• Format: Article
• Language: English; English; English
• Published: Springer London 2019
• Subjects: T Technology (General); TA401 Materials of engineering and construction
• Online Access: http://irep.iium.edu.my/76469/19/76469_Investigation%20of%20process%20parameters_new.pdf; http://irep.iium.edu.my/76469/2/76469_Investigation%20of%20process%20parameters_scopus.pdf; http://irep.iium.edu.my/76469/3/76469_Investigation%20of%20process%20parameters_wos.pdf; http://irep.iium.edu.my/76469/; https://link-springer-com.ezproxy.um.edu.my/article/10.1007%2Fs00170-019-03603-7

Micro dry wire electrical discharge machining (μDWEDM) is a process where gas is used as the dielectric fluid instead of a liquid. In this process, certain modifications of wire electrical discharge machining (WEDM) are needed during the machining operation to achieve stable machining. Smooth and stable machining operation in μDWEDM process remains as a critical issue. Thus, this paper presents the investigation of process parameters for a stable μDWEDM process. The investigation was performed on a stainless steel (SS304) with a tungsten wire as the electrode using integrated multi-process machine tool, DT 110 (Mikrotools Inc., Singapore). The experimentation method used in this phase was a conventional experimental method, one-factor-at-a-time (OFAT). Types of dielectric fluid, dielectric fluid pressure, polarity, threshold, wire tension, wire feed rate, wire speed, gap voltage, and capacitance were the controlled parameters. The machined microchannels were observed using scanning electron microscope (SEM). Stable and smooth machining operation of μDWEDM was found to be with compressed air as the dielectric fluid, workpiece positive polarity, 24% threshold, 0.0809 N wire tension, 0.2 μm/s wire feed rate, and 0.6 rpm wire speed.