Search Results - (( parameter evaluation method algorithm ) OR ( parameter evaluation sensor algorithm ))

Refine Results
  1. 1

    Calibration of optical based silicone tactile sensor based on image deformation technique / Abdul Halim Esa by Esa, Abdul Halim

    Published 2016
    “…To evaluate the performance of the algorithm, this proposed optical tactile sensor compares the results of these three parameters that give a better accuracy with respect to sensitivity value, low hysteresis and high repeatability. …”
    Get full text
    Get full text
    Thesis
  2. 2

    Novel chewing cycle approach for peak detection algorithm of chew count estimation by Selamat, Nur Asmiza, Md Ali, Sawal Hamid, Ismail, Ahmad Ghadafi, Ahmad, Siti Anom, Minhad, Khairun Nisa'

    Published 2025
    “…The peak detection algorithm identifies key signal features, while PSO optimizes the peak prominence and width parameters to minimize the mean absolute error (MAE) in chew count estimation. …”
    Get full text
    Get full text
    Article
  3. 3

    Novel chewing cycle approach for peak detection algorithm of chew count estimation by Selamat, Nur Asmiza, Md Ali, Sawal Hamid, Ismail, Ahmad Ghadafi, Ahmad, Siti Anom, Minhad, Khairun Nisa’

    Published 2025
    “…The peak detection algorithm identifies key signal features, while PSO optimizes the peak prominence and width parameters to minimize the mean absolute error (MAE) in chew count estimation. …”
    Get full text
    Get full text
    Get full text
    Article
  4. 4

    Delay and energy-aware routing for efficient data collection in wireless sensor networks / Ihsan Ali by Ihsan , Ali

    Published 2024
    “…Both Bat Algorithm parameters and AFW parameters are adaptively tuned to balance exploration and exploitation throughout the optimization process. …”
    Get full text
    Get full text
    Get full text
    Thesis
  5. 5

    Extracting crown morphology with a low-cost mobile LiDAR scanning system in the natural environment by Wang, Kai, Zhou, Jun, Zhang, Wenhai, Zhang, Baohua

    Published 2021
    “…The algorithm defined in this study was evaluated with manual measurements as reference, and the morphological parameters of the canopy obtained using the LOAM and LeGO-LOAM algorithms as the basic framework were compared. …”
    Get full text
    Get full text
    Get full text
    Article
  6. 6
  7. 7

    Development an accurate and stable range-free localization scheme for anisotropic wireless sensor networks by Han, Fengrong

    Published 2022
    “…This study developed an optimized variation of the DV-Hop localization algorithm for anisotropic wireless sensor networks. …”
    Get full text
    Get full text
    Thesis
  8. 8

    Transmission path optimization Based on Efficiency Communication System by Jin Fan, Kit, Guan Lim, Sin, Helen Ee Chuo, Min, Keng Tan, Ali Farzamnia, Tze, Kenneth Kin Teo

    Published 2022
    “…In this paper, routing attribute table that is maintained by the nodes, the density and relative distance of node distribution, is used to determine the clustering method. At the same time, the developed algorithm combines the relative position of the cluster and the base station to further improve the routing method of the sub-cluster head, Finally, the algorithm analyzes the influence of different parameters on the transmission path, and use the simulation experiments to evaluate the conclusions.…”
    Get full text
    Get full text
    Get full text
    Get full text
    Conference or Workshop Item
  9. 9

    Even-odd scheduling based energy efficient routing for wireless sensor network (WSN) / Muhammad Zafar Iqbal Khan by Khan, Muhammad Zafar Iqbal

    Published 2022
    “…The performance of the proposed routing algorithm has been evaluated through simulations of well-known software MATLAB. …”
    Get full text
    Get full text
    Thesis
  10. 10

    A new routing mechanism for energy-efficient in bluetooth mesh-low power nodes based on wireless sensor network by Almuslehi, Hussein Saad Mohammed

    Published 2023
    “…It evaluates system formation methods, hierarchical structures, and leader selection criteria, comparing various parameters to identify factors influencing node formation and routing. …”
    Get full text
    Get full text
    Get full text
    Thesis
  11. 11

    A Novel Approach to Estimate Diffuse Attenuation Coefficients for QuickBird Satellite Images: A Case Study at Kish Island, the Persian Gulf. by Pradhan, Biswajeet, Mohd Shafri, Helmi Zulhaidi, Mansor, Shattri, Kabiri, Keivan, Samim-Namin, Kaveh

    Published 2013
    “…Since the aforementioned algorithm has been developed for other types of sensors, an approach using weighted mean value of parameters for SeaWiFS, MERIS, VIIRS, and OCTS sensors were employed to estimate parameter values for QuickBird image. …”
    Get full text
    Get full text
    Article
  12. 12

    An efficient backoff algorithm for IEEE 802.15.4 wireless sensor networks by Dahham, Zahraa, Sali, Aduwati, Mohd Ali, Borhanuddin

    Published 2014
    “…In this paper, we propose an efficient backoff algorithm, called EBA-15.4MAC that enhances the performance of slotted CSMA/CA algorithm. …”
    Get full text
    Get full text
    Article
  13. 13

    Sensorless Adaptive Fuzzy Logic Control Of Permanent Magnet Synchronous Motor by Hafz Nour, Mutasim Ibrahim

    Published 2008
    “…Both experimental and simulation results obtained from the HMRASC and the position angle estimation algorithms showed superior results compared to other methods presented in the literature.…”
    Get full text
    Get full text
    Thesis
  14. 14

    Photogrammetric low-cost unmanned aerial vehicle for pothole detection mapping / Shahrul Nizan Abd Mukti by Abd Mukti, Shahrul Nizan

    Published 2022
    “…The study set four main objectives to achieve its aim: (1) To analyse RGB and multispectral sensor calibration, (2) To evaluate the optimal flight parameters for pothole modelling production using RGB imagery, (3) To investigate various classifier algorithms and band combinations for pothole region areas using multispectral imagery and (4) To validate geometric information from the extracted pothole. …”
    Get full text
    Get full text
    Thesis
  15. 15

    TDMA scheduling analysis of energy consumption for iot wireless sensor network by Islam, Md Ashikul

    Published 2019
    “…Network Simulator NS2.35 is the tool used for simulation of the project. For the evaluation of the performance the parameters used are Energy consumption (Joules). …”
    Get full text
    Get full text
    Thesis
  16. 16

    Optimizing Visual Sensor Coverage Overlaps for Multiview Surveillance Systems by Altahir, A.A., Asirvadam, V.S., Hamid, N.H.B., Sebastian, P., Saad, N.B., Ibrahim, R.B., Dass, S.C.

    Published 2018
    “…The obtained solutions from the dynamic programming technique are evaluated with respect to local and global greedy search algorithms. …”
    Get full text
    Get full text
    Article
  17. 17

    Optimizing Visual Sensor Coverage Overlaps for Multiview Surveillance Systems by Altahir, A.A., Asirvadam, V.S., Hamid, N.H.B., Sebastian, P., Saad, N.B., Ibrahim, R.B., Dass, S.C.

    Published 2018
    “…The obtained solutions from the dynamic programming technique are evaluated with respect to local and global greedy search algorithms. …”
    Get full text
    Get full text
    Article
  18. 18

    Optimization Method Using Modified Harmony Search For Coverage And Energy Efficiency In Wireless Sensor Network by Halim, Nurul Hamimi

    Published 2018
    “…Coverage and energy efficiency metrics are two fundamental issues for almost all types of application in wireless sensor network (WSNs).Coverage reflects how well an area is monitored by sensor nodes and in energy efficient networks where less energy is consumed to provide the same level of services.These twin specifics are presented to evaluate the performance of a wireless sensor network.Due to its simplicity and ease of analysis,full coverage is widely implemented in many theoretical studies.However,sometimes full coverage is not the best way to represent some real-world application due to its strong restrictions and its deterministic characteristics.In this thesis,Modified Harmony Search algorithm (MHS) is proposed to achieve a sensor node deployment such that the covered area is optimal and data transfer has low energy consumption.Through computer simulations, experimental results verified that the proposed method improved the coverage of area in compare to some related methods.Based on the result obtain from every experiments,coverage area percentage performance is affected by the number of hotspots.This is shown by Harmony Search (HS) based method where the coverage area percentage increases as the number of hotspot increase. …”
    Get full text
    Get full text
    Get full text
    Get full text
    Thesis
  19. 19

    Improvement of land cover mapping using Sentinel 2 and Landsat 8 imageries via non-parametric classification by Myaser, Jwan

    Published 2020
    “…Furthermore, using SVM requires the user to set certain parameters values, including kernel type and kernel parameters, since these parameters own a significant effect on the effectiveness of SVM. …”
    Get full text
    Get full text
    Thesis
  20. 20

    Activity recognition using optimized reduced kernel extreme learning machine (OPT-RKELM) / Yang Dong Rui by Yang , Dong Rui

    Published 2019
    “…One of the major research problems is the computation resources required by machine learning algorithm used for classification for HAR. Numerous researchers have tried different methods to enhance the algorithm to improve performance, some of these methods include Support Vector Machine (SVM), Decision Trees, Extreme Learning Machine (ELM), Kernel Extreme Learning Machine (KELM), and Deng’s Reduced Kernel Extreme Learning Machine (RKELM). …”
    Get full text
    Get full text
    Get full text
    Thesis