Search Results - (( parameter estimation supply algorithm ) OR ( java implication based algorithm ))

Refine Results
  1. 1

    A comparison of four different estimation approaches for prognostic survival oral cancer model by Wan Ahmad, Wan Muhamad Amir, Yaqoob, Muhammad Azeem, Mohd Ibrahim, Mohamad Shafiq

    Published 2020
    “…Each method is illustrated separately and compared according to their coefficient parameter. An approach is considered by adding a bootstrapping technique for each handling ties method and a complete SAS algorithm is supplied for each proposed method, including methods for handling ties.…”
    Get full text
    Get full text
    Get full text
    Article
  2. 2
  3. 3
  4. 4

    Design Optimization of 3-Phase Rectifier Power Transformers by Genetic Algorithm and Simulated Annealing by K.S., Rama Rao, Md Hasan, Khairul Nisak

    Published 2008
    “…Two non-linear programming techniques, GA and SA are applied for the estimation of transformer design parameters and the results are compared. …”
    Get full text
    Get full text
    Citation Index Journal
  5. 5

    Voltage and load profiles estimation of distribution network using independent component analysis / Mashitah Mohd Hussain by Mohd Hussain, Mashitah

    Published 2014
    “…First, voltage profile on source distribution system is estimated. The voltage profile is predicted using Independent Component Analysis (lCA) algorithm. …”
    Get full text
    Get full text
    Thesis
  6. 6

    Design Optimization of 3-phase rectifier power transformers by Genetic Algorithm and Simulated Annealing by K.S., Rama Rao, K.N., Mohd Hassan

    Published 2008
    “…Two non-linear programming techniques, GA and SA are applied for the estimation of transformer design parameters and the results are compared. …”
    Get full text
    Get full text
    Citation Index Journal
  7. 7

    Design Optimization of 3-phase rectifier power transformers by Genetic Algorithm and Simulated Annealing by K.S., Rama Rao, K.N., Mohd Hassan

    Published 2008
    “…Two non-linear programming techniques, GA and SA are applied for the estimation of transformer design parameters and the results are compared. …”
    Get full text
    Get full text
    Conference or Workshop Item
  8. 8

    Genetic algorithm for design optimization of 3-phase semi-conductor rectifier power transformers by K.S.R, Rao

    Published 2007
    “…Powell's direct search method as optimization technique is applied for the estimation of transformer design parameters and compared with the results obtained using GA. …”
    Get full text
    Get full text
    Get full text
    Conference or Workshop Item
  9. 9

    Investigation of impedance-based fault location techniques in power system network / Tan Feng Jie by Tan, Feng Jie

    Published 2019
    “…The simulated voltage and current waveforms are applied to the algorithms of 4 fault locations methods to compute the estimated fault distance. …”
    Get full text
    Get full text
    Get full text
    Thesis
  10. 10

    Optimization of operational policies for the Minab Reservoir, Southern Iran by Gholampoor, Mohammad

    Published 2012
    “…Rule curve for five possible scenarios were optimized by using Genetic Algorithms. The agricultural management optimization was applied to optimize the parameters like area, relative yield water requirements and irrigation efficiency. …”
    Get full text
    Get full text
    Thesis
  11. 11

    Indirect Rotor Field Oriented Control of Induction Motor With Rotor Time Constant Estimation by Moh'd Radwan, Eyad Moh'd

    Published 2004
    “…Since the position of the rotor flux vector is estimated in an IRFOC scheme, and is dependent on the motor model (more specifically the rotor parameters), these parameters must be obtained accurately and match the motor parameters at all times. …”
    Get full text
    Get full text
    Thesis
  12. 12
  13. 13
  14. 14
  15. 15

    IRFOC induction motor with rotor time constant estimation modelling and simulation by Radwan, E., Mariun, N., Aris, I., Bash, S. M., Yatim, Abdul Halim Mohamad

    Published 2005
    “…Increased oscillations in the estimated inverse rotor time constant appeared at lower speeds (below 10 per cent of rated speed) due to drift in a PI regulator (used at the estimator side), which was tuned under rated operating conditions and using parameters nominal values.Research limitations/implications– This estimation scheme is limited when near zero speed operation is demanded; otherwise it gives a simple and practical solution. …”
    Get full text
    Get full text
    Get full text
    Article
  16. 16

    Power prediction using the wind turbine power curve and data-driven approaches / Ehsan Taslimi Renani by Ehsan Taslimi , Renani

    Published 2018
    “…To obtain the unknown vector of parameters of the MHTan, three heuristic optimization algorithms are employed to minimize the sum of squared residuals. …”
    Get full text
    Get full text
    Get full text
    Thesis
  17. 17

    Optimization of hydropower reservoir system using genetic algorithm for various climatic scenarios by Tayebiyan, Aida

    Published 2015
    “…Since hedging policies are usually applied to distribute the water supply, the power-supply also scatter in the simulation period. …”
    Get full text
    Get full text
    Get full text
    Thesis
  18. 18
  19. 19

    Using remote sensing and GIS for assessment of irrigation performance in the Al-Hindiyah Barrage, Babil City, Iraq by Jaber, Hussein Sabah, Mansor, Shattri, Pradhan, Biswajeet, Ahmad, Noordin

    Published 2016
    “…Actual and potential parameters of evapotranspiration used in determination of these indicators were estimated depending on the method of Surface Energy Balance Algorithm for Land (SEBAL) by using a series of Landsat OLI satellite images. …”
    Get full text
    Get full text
    Article
  20. 20

    An analytical strategy for energy storage sizing in isolated microgrid with PV source by Mohd Fauzi, Mohamad Yusof, Nor Su’aida, Yusof, Abu Zaharin, Ahmad

    Published 2018
    “…The proposed uses the simple analytical approach that taking into account the parameters of PV power source, charging/discharging level and estimated load profile. …”
    Get full text
    Get full text
    Get full text
    Conference or Workshop Item